Realizing a Highly Compact Particulate Matter Sensor With a MEMS-Based Resonant Membrane

With increasing air pollution levels across the globe, there has been a significant increase in the global health crisis. But the problem remains unchecked in various parts of the world, due to the lack of low-cost and high accuracy air quality sensors. This paper proposes a new technique based on piezoelectric micro-electro-mechanical systems (MEMS) to measure the amount of particulate matter (PM) suspended in the air. Commercially available PM sensors suffer from many disadvantages - namely size, cost, and accuracy. Previous attempts at using MEMS to measure PM have failed to make a significant impact due to the lack of a mechanism to sort the suspended particles based on their sizes and clear the sensing area from the particles after each measurement. The sensor proposed here, consisting of i) a piezoelectric resonating membrane, ii) a virtual impactor, and iii) a thermophoretic plate attempts to address the issues faced by other sensors, while achieving a very compact size and a significantly lower cost. On exposing the sensor to suspended particles in a container, a significant shift in the resonant frequency is observed, once the particles settle on the resonating membrane. The gradual shift in the resonant frequency supports the application of the proposed sensing solution to measure the mass of the PM in the air.

• Publication year

  2019

• Venue

  Italian National Conference on Sensors

• Publication date

  2019-10-01

• Fields of study

  Materials Science, Computer Science, Engineering, Environmental Science

• Identifiers
  DOI 10.1109/SENSORS43011.2019.8956505
• External record

  Open on Semantic Scholar

• Source metadata

  Semantic Scholar

• No claims are published for this paper.

• No concepts are published for this paper.

• Reduced-gap CMUT implementation in PolyMUMPs for air-coupled and underwater applications

  2019cited by this paper
• A Novel Particulate Matter 2.5 Sensor Based on Surface Acoustic Wave Technology

  2018cited by this paper
• A resonant cantilever based particle sensor with particle-size selection function

  2018cited by this paper
• Piezoelectric Bulk Mode Disk Resonator Post-Processed for Enhanced Quality Factor Performance

  2017cited by this paper
• Bulk Mode Disk Resonator With Transverse Piezoelectric Actuation and Electrostatic Tuning

  2016cited by this paper
• Capacitive micromachined ultrasonic transducer (CMUT) as a chemical sensor for DMMP detection

  2011cited by this paper
• Characterization of fine particle emissions from incense burning

  2011cited by this paper
• A review of atmospheric aerosol measurements

  2000cited by this paper
• Micromachined two-dimensional array piezoelectrically actuated transducers

  1998cited by this paper
• Surface micromachined capacitive ultrasonic transducers

  1998cited by this paper
• Silicon micromachined ultrasonic immersion transducers

  1996cited by this paper

• Preparation and Characterization of Affordable Experimental Setup for Particulate Matter Sensing

  2024cites this paper
• Towards the World’s Smallest Gravimetric Particulate Matter Sensor: A Miniaturized Virtual Impactor with a Folded Design

  2022cites this paper
• Sensitivity Enhancement of Thermal Piezoresistive Resonant MEMS Sensors Using Mechanical Coupling and DC Tuning

  2022cites this paper
• MEMS sensor for detection and measurement of ultra-fine particles

  2022cites this paper
• MEMS Sensor for Detection and Measurement of Ultra-Fine Particles: A Review

  2021cites this paper
• Piezoelectric Mems for Microparticles Detection

  2021cites this paper
• A PM2.5 Sensor Module Based on a TPoS MEMS Oscillator and an Aerosol Impactor

  2020cites this paper
• A Thin-Film Piezoelectric-on-Silicon MEMS Oscillator for Mass Sensing Applications

  2020cites this paper
• Preparation and Characterization of Affordable Experimental Sensors Array for Particulate Matter Sensing

  year unknowncites this paper